
MAZDASPEED MOTORSPORTS DEVELOPMENT carries the following Spec Miata parts to help you build your car.
The suspension kit includes an AWR Coil-Over kit with revised bump stops, Eibach 700lb front and 325 lb rear ERS race springs, and Eibach front and rear sway bar kit.
| Description | Part Number | |
| 1.6 Liter Miata | 000-02-5500 | |
| 1.6 Suspension Kit | K-SPEC-M5-SUSP | |
| Comp Limited Slip* | ||
| Spec Miata Exhaust Muffler (add converter pipe)(90-97) | 0000-06-5425 | |
| Converter replacement pipe 1.6 | 0000-06-5423 | |
| Converter replacement pipe 1.8 (94-97) | 0000-06-5424 | |
| *Axle stubs, p/n T005-27-270B, are needed for cars that came with a factory viscous-type limited slip. Vehicles with open diffs don't need these. | ||
| 1.8 Suspension Kit (1st Gen Miata) | K-SPEC-M5-SUS8 | |
| Throttle Restrictor (94-95) | CONTACT SCCA ENTERPRISES | 303-693-2111 |
| Throttle Restrictor (96-97) | CONTACT SCCA ENTERPRISES | 303-693-2111 |
| Torsen Limited Slip (1.8 only) | MM03-27-200 |
| 1.8 Suspension Kit (Second Gen Miata) | K-SPEC-M5-SUS9 | |
| Throttle Restrictor | CONTACT SCCA ENTERPRISES | 303-693-2111 |
| Torsen Limited Slip | MM03-27-200 |
| Green™ Air Filter (drop in) 1.6 or 1.8 | 0000-06-5201-GN |
|
| Green™ Air Filter (drop in) (99-05) | 0000-06-5202-GN | |
| Stainless Steel Braided Brake Lines (90-05) | 0000-03-5211 | |
Subframe Bracing - 90-93 only (94-05 is already installed) |
NA75-56-3AY | |
Subframe Bracing Tabs (helpful to install bracing, or make your own) |
0000-04-5999 | |
R-package chin spoiler (90-97) |
0000-86-510A |
|
| Sport Package chin spoiler 99-05 | NC10-V4-900F primered |
|
| Tie Down/Tow Hooks | 0000-04-5998 (Includes one front and one rear tow hook with 2" diameter hole) | |
| Adjustable sway bar end link - (order 4, 90-97 only) | 0000-04-5499 | |
| Competition Aluminum Radiator 90-97 | 0000-01-5501 |
|
| Competition Aluminum Radiator 99-05 | 0000-01-5503 | |
| Hard Top | NCY1-R1-81XB-98 | |
| Hard Top Bracket Kit | 0000-04-5997 | |
| Evaporator Replacement Tube | NA01-61-150A | Used when removing the evaporator to connect heater box to blower. |
| Evaporator Hole Plugs | 0187-53-134 , 1708-61-031 , & B499-62-868 | Two fill holes in firewall and one fills the drain hole in the transmission tunnel. |